UltraMedia CarSat-55 Bedienungsanleitung Seite 29

2. Additional assembly with adhesive.
a) Transfer the outline of the mounting plate to the vehicle roof when it
is screwed on.
b) After loosening the screws, clean the marked area and the mounting
plate.
c) Roughen the surface slightly and apply the assembly adhesive evenly.
d) Press the system evenly onto the mounting surface.
e) Then screw the antenna back on.
f) Note the drying time of the adhesive used.
g) Use commercially available body sealant to seal the mounting
screws.
h) Remove excess adhesive residue.
INSTALLATION ON THE ROOF
3. Assembly of the cable entry
a) Transfer the outline of the cable entry to the vehicle roof.
b) Drill the corresponding holes for cable entry into the vehicle interior.
c) Seal the cable entry.
d) Glue the cable bushing to the vehicle roof using a suitable mounting
adhesive.
e) Note the drying time of the adhesive used.
f) Remove excess adhesive residue.
29