Power Supply - AUDIOropa xepton RP-1 Bedienungsanleitung

3.7 Basic audio output high / low
Apart from the volume control, it is possible to adjust the basic audio output
level. A higher audio output will raise the maximum volume – this might be re-
quired in noisy surroundings.
On the powered-up device, press and hold the MODE-button of the according
unit for 3 seconds. The symbol »GRP« in the display will blink.
Press the MODE button four times. The »UH« symbol is shown in the display.
By using the and -buttons, select UH (high output) or UL (normal output).
After the selection, wait for 3 seconds to set the selected output level.
Please note:
Selecting »UH« can cause white noise and should only be used in loud envi-
ronments. We recommend the default setting »UL«.

3.8 Power supply

The repeater is powered over either one of the USB connectors on the rear of
the device. The device can be powered by a regular USB powerpack for mo-
bile phones and can hereby be used in a portable manner.
Connect the powerpack to the USB connector on the rear of the device. The
power consumption of the device is approx. 400mA.
English 19