Volume Up / Down - AUDIOropa xepton RP-1 Bedienungsanleitung

3.3 ID selection
For full two-way applications between units A and B, both units must be set as
MASTER. Units are defined as MASTER by setting their ID to »00«. If further
xepton TRX-1 transceivers are to be included within the according group, each
TRX-1 needs to have its ID set to any number but »00«, as there only can be
one master unit within a channel group. To transmit voice from the microphone,
the TALK-button of additional TRX-1 units needs to be pressed for one second
in order to enable the TALK function.
When using the transmitters T-1 and/or TX-1, the unit of the repeater assigned
to their channel group must not be set to MASTER.
To set a unit as MASTER, continue as follows:
On the powered-up device, press and hold the MODE-button for 3 seconds.
The symbol »GRP« on the display will blink. Press the MODE-button again. The
symbol »ID« will start to blink.
By using the and -buttons, select the ID from 00 to 99. Setting the ID to
»00« will define the unit as MASTER. After the selection, wait for 3 seconds to
set the selected ID number.
Please note:
- Within a channel group, one device must be set as MASTER.
- Within a channel group, there must only be one device set as MASTER.
The chart on page Seite 22 shows possible setups and configurations along
with their directions of communication.

3.4 Volume up / down

The volume of the according unit can be adjusted through 9 levels.
On the powered-up device, press the and -buttons to adjust the volume
between 01 (low) and 09 (high) as desired.
English 17