How To Use; Group Selection - AUDIOropa xepton RP-1 Bedienungsanleitung

2.2 Basic function method
The repeater RP-1 serves to increase the transmission range and also to sup-
ply one xepton channel group with the transmission of a different xepton chan-
nel group.
The device features two control- and display units A and B. These are assigned
to a different channel group respectively, the transmission between the two
units is internal.

3. How to use

3.1 Power ON / OFF
Connect the device with the USB power supply and cable, by using either one
of the two USB sockets on the rear of the device. Use the ON/OFF switch to
switch the device on. The LC displays will illuminate and the default volume
setting „VOL 03" is indicated respectively.
Use the ON/OFF switch again to switch the device off.

3.2 Group selection

The two control units A and B must be set to different channel groups. Switch the
device on and press and hold one of the MODE buttons for 3 seconds.
The symbol »GRP« in the display above the pressed MODE-button will blink.
Select a group number of your choice between »00« and »39« by pressing the
and -buttons. After the selection, wait for 3 seconds for the selected group
number to be set.
Please note: For both units, choose a group number with a large difference (e.g.
A:00 / B:20), as this will enhance the performance.
Press and hold the other MODE-button for 3 seconds. The selection of the group
number is as described above, but choose a different channel number.
Transmitters and receivers must be set to the same group number if they are to
communicate with each other.
English 16