Microphone Sensitivity - AUDIOropa xepton RP-1 Bedienungsanleitung

3.5 Monitoring function On / Off
The monitoring function enables you to hear your own voice over the system.
Proceed as follows if you wish to activate the monitoring function:
On the powered-up device, press and hold the MODE-button of the according
unit for 3 seconds. The symbol »GRP« in the display will blink.
Press the MODE button two times. The »SO« symbol in the display will blink.
By using the and -buttons, select »SO« to activate the monitoring func-
tion or »SF« to deactivate it. After the selection, wait for 3 seconds for the selec-
ted function to be set.
Please note:
The default setting is »SF« (monitoring deactivated).

3.6 Microphone sensitivity

The microphone sensitivity for the according unit can be adjusted through 5
levels, as needed in regards to environmental requirements:
On the powered-up device, press and hold the MODE-button for 3 seconds.
The symbol »GRP« in the display will blink.
Press the MODE button three times. The »C1« symbol in the display will blink.
By using the and -buttons, select between C1 (low sensitivity) and C5
(high sensitivity).
Please note: The default setting is C3.
English 18