Air-Regulator - Berner BPT-TORNADOR GUN BLACK Bedienungsanleitung

Operating instructions:
1 Remove loose soiling from the surface you wish to clean (brush or vacuum clean)
2 Turn the green rocker lever into the vertical position to activate the (cleaning) liquid in the
bottle. Pls. note to insert the cleaning liquid just before application and remove
remaining liquid after use to avoid that the hoses and the suction filter get choked by
chemical residues.
3 Important: Hold the cleaning spout at a distance of only 1-3 cm from the surface you are
cleaning and in angle of approx. 45°.
4 Press the "trigger" all the way; move the BPT-TORNADOR GUN BLACK slowly with circular
motions over the surface you are cleaning.
5 Turn the green rocker lever into the horizontal "air only" position, press the trigger and dry the
surface you have cleaned.
6 To remove any remaining moisture, wipe the cleaned surface with a dry cloth.
CARE AND MAINTENANCE after use
•
Clean the spout as follows: Turn the green control switch to the horizontal "air only" position,
hold the cleaning nozzle in a bucket and press the trigger all the way in order to remove any
soiling from the nozzle.
•
Additional you need to flush the hoses and the suction filter after every use. For this
please insert pure water in the empty and clean cup and attach it to the unit as usual.
Turn the green rocker lever into the vertical position and press the trigger for at least 20
seconds to flush and clean the related parts. If needed clean the suction filter
separately by pulling of the metal-ball from the suction hose and using a air blow gun
to clean the integrated filter.
•
Replace damaged parts immediately for your own safety. The rotate-set, nozzle, hoses and
gaskets are consumable parts. Pls. ask your local dealer for related original-spare parts.
•
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply,
when not in use, before changing accessories or when making repairs.
REQUIRED AIR RATE
To perform to its full potential, the BPT-TORNADOR GUN BLACK requires a constant air pressure
between 5.5 and 6.3 bar (78 to 90 psi).
CAUTION: Constant air rates vary depending on the size and power of the compressor. Always make
sure that the tank and the air hoses are free of impurities of any kind

Air-regulator

The BPT-TORNADOR GUN BLACK requires a air pressure between 5,5 and 6,3 bar (78-90 psi) to
perform to its full potential. Many compressors will deliver a higher pressure.
With the air-regulator you are in the position to control the air volume according to your requirements.
Lower pressure means more liquid, higher pressure less liquid.
Norice : Basically we recommend to install a additional air pressure regulator
with max. 6,5 bar (93 psi) and use the air-volume-control-valve for fine
adjustment.