Use - gourmetmaxx SM-1504 Gebrauchsanleitung

Use

PLEASE NOTE!
■ Do not place any objects or hands in the mixing bowl when the device is in operation.
■ Make sure that the rotary switch is in the 0 position before the device is connected to
the mains power.
■ Do not overfill the mixing bowl (max. 1.5 kg). This might result in the device over-
heating or damage to the motor.
■ Never switch on the device if the tilting mixer head has not been flipped down!
■ Never flip up the tilting mixer head during use.
■ Never fill the device with hot food or liquids! The contents must not be hotter than
50°C. Allow hot food to cool down before processing it any further with the device.
■ Use the device for no more than 3 minutes without interruption to prevent over-
heating. Allow the device to cool down before using it again.
The device is equipped with overload protection; the device switches off if it is
overloaded. In this case, pull the mains plug out of the plug socket and allow the
device to cool down for approx. 10 minutes. The device is then ready to be used
again.
1. Place the device with sufficient clear space above it and on all sides on a dry, flat and
solid surface. Be aware that there must be sufficient clear space above to allow the
mixer head (12) to be flipped up.
2. Make sure that the suction cups (8) stick to the surface correctly.
3. Place the ingredients you want into the mixing bowl (10).
4. Insert the mixing bowl into the main device (7) and attach the attachment you want
(see "Attaching / Detaching Accessories").
5. The mains plug should be connected to a plug socket that has been properly installed.
The LED ring (2) flashes. The device is in standby mode.
6. Use the rotary switch (3) to set an appropriate speed level:
0 Off
1 – 3
Slow mixing, stirring and kneading
4 – 6 Fast mixing, stirring and kneading
P
Pulse (short mode at top speed)
To activate pulse mode, the rotary switch must be held in the P position for the
length of time you want.
The mount (11) moves in a circular motion in the mixing bowl and the attachment rotates
around its own axis. The LED ring is lit up constantly while the device is switched on.
7. To switch off the device, move the rotary switch to the 0 position. The LED ring
flashes. The device is in standby mode.
8. Remove the mains plug from the plug socket. The LED ring goes out.
CAUTION – Danger of injury due to rotating device parts! Always wait until
the attachment has come to a complete standstill before flipping up the mixer
head.
9. Remove and clean the used attachment and the mixing bowl (see "Cleaning and
Storage").
19 EN