Safety Considerations; System Description - Dustcontrol S32000 Originalbetriebsanleitung

Safety Considerations

Read all instructions before the machine/installation is
commissioning.
Th e equipment must be installed and maintained properly
by qualifi ed personnel who have study this user instruction.
Dustcontrol does not take responsibility for defective instal-
lation or maintenance.
Warning! When using electric machines, basic safety
precautions should always be
risk of fi re, electric shock and personal injury, including the
following:
1. Work area environment
Keep the area around the central unit clean. Do not
store or work with fl ammable liquids or gases near
the machine.
2. Overload
If there is an alarm signal it should be carefully
checked out to see that the machine is un damaged. If
there are any damaged parts these should be repaired
by a Dustcontrol authorised service centre. Always
follow the regulations pertinent to the material you
are working with. Do not use the machine for pur-
poses that it is not intended for.
3. Bodily injuries
Never let the suction come in contact with parts of
the body, for example a hand. Th e vacuum producer
generates a high negative pressure, severe injury may
result.

System Description

Th e S 32000, S 34000, S 34000X and S 46000 are statio-
nary dust separators for the source extraction of air borne
pollutants and for cleaning.
Most of the dust is separated in the cyclone. Th e partic-
les are collected in the bottom of the fi lter unit and are
automatically emptied when the vacuum producer is shut
down.
By the internal fi lter arrangement 99.9 % (DIN 24184/3)
of the fi nest particles are separated from the air.
All manuals and user guides at all-guides.com
followed to reduce the
S 32000, S 34000, S 34000X, S 46000 - 11
4. Electricity
A separate lockable disconnect must be installed
where it is readily accessible to the vacuum producer.
Do not repair the electric components yourself, get
somebody qualifi ed. Faults may cause injury. See also
under section 8, 'Warnings'.
5. Important measure
Before working on the dust separator - always turn
off and lock the disconnect of the vacuum producer.
6. Maintain the machine with care
Always clean fi lter before taking of the discharge
arrangement. Always follow the regulations pertinent
to the material that you are working with. Follow
instructions.
7. Checking for damage
Check the machine regularly for damage. If there
are any damaged parts these should be repaired by a
Dustcontrol authorised service centre.
8. Warning
Use only accessories and replaceable parts which are
available in Dustcontrol catalogue. When using non-
genuine parts, especially fi l-ters and plastic sacks,
dust leaks could occur which may be hazardous to
health.
Th e fi lter is cleaned with air pulse against the fl ow of
extracted air. Th is arrangement provides for very eff ective
cleaning while at the same time giving long fi lter life. S
32000, S 34000, S 34000X and S 46000 are of modular
construction. Th e inlet module can for example be both
rotated and reversed.
Additional module rings can be installed to increase the
storage capacity of the fi lter unit.
Th e X model is equipped with larger fi lter area and an
extra module ring.
As standard the dust is collected in a plastic sack, contai-
ners etc. are available as accessories.
Part No 9065, 94160