Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To turn the blower vac on.
1. Plug the power cord into an approved electrical exten-
sion cord, and turn the extension cord on. Attach the
extension to one side of the cable hook as shown in
fig. 16.
2. Ensuring the blower vac is directed in a safe direction,
depress the trigger switch(1) and the blower vac will
start.(fig 12)
Be sure to be holding the blower vac firmly on start up.
To turn the blower vac off
To turn the blower vac "off", simply release the trigger
switch.
Important ! After you have turned the blower vac off, do
not leave the product until the electrical supply.
Select the blow operation
1. Move the blower/vacuum selector level(2) towards the
back of the housing (fig. 13)
When the blower operation is selected , air is drawn up
through the large blow/vac tube and then expelled at a
much higher velocity in the lower cavity below the blow/
vac tube.
Ensure when the blower operation is selected the blower
vac is pointed ,directed and used in a safe manner. Do
not direct the air flow from this blower vac directly or
indirectly towards another person.
To select the vacuum operation
1. Push the selector level forward(fig. 14).
When the vacuum operation is selected, air and debris is
drawn up through the large vac tube, and forced through
the mulching impellor.
The debris is mulched and then blown down into the
collection bag.
Important ! Always ensure the collection bag is correctly
attached as per the "Fitting the collection bag " section
in this manual.
Always be aware of what is being drawn up into the
blow/vac tube . This product is only designed for garden
debris like leaves ,twigs and garden cuttings.
Importment notes when using the blower/
vacuum selector knob(7)
Do not force the lever . The lever should move with very
little resistance. If the lever is difficult to move , discon-
nect the power supply ,remove the collection bag and
ensure debris ,dirt or mud has not jammed the lever
inside the large round outlet.
When selecting either of the operation ,ensure the selec-
tor lever is fully in one position of the other ,not half way.
Speed Controller
(Fig.15)
Produkt BVN 2500 has a adjustable speed controller and
therefore adjustable vacuuming and blowing. The speed
is fully variable from 6000 Rpm to 14000 Rpm.
To empty the collection bag
The collection bag is attached to the blower vac in 2
places. It is not necessary to remove the collection bag
from the blower vac when the bag needs to be emptied.
• The rear of the bag is fitted with a full length zip.
• Simply open the zip and empty the contents.
• Ensure to close the zip prior to operating the blower
vac.
Tips for using your blower vac
The following points may assist you in the operation of
the blower vac.
• Always try and vacuum dry leaves ,cuttings or general
garden debris.
• Wet materials id difficult to mulch and also can cause
the blower vac to clog.
• If the leaves etc. are damp ,then use the blower vac
in blow selection to pile the leaves etc. into one area,
vac and mulch the leaves when dry.
• Avoid using the vac on areas where there are stones,
or other hard objects. These objects will damage the
impellor of the blower vac.
• It is also advisable not to allow the blower vac to pick
up soil. Soil generally contains moisture and when
combined with other garden debris can clog the
blower vac.
• The blower vac is not a garbage disposal unit. Do not
attempt to mulch any material than general garden
debris.
• For better performance and comfort, it is recommend-
ed the collection bag is emptied when it becomes ap-
proximately half full. This reduces the weight and also
allows the vac operation to perform at its highest level.
Maintenance and storage information
Prior to cleaning or any maintenance, always ensure the
power plug has been removed from the electrical power
supply. When you have finished using the blower vac,
always check to make sure the product is clean and free
of dirt and debris. This is important around the selector
lever flap which is just inside the round outlet. To check
this area, remove the collection bag and ensure this area
inside the outlet tube is free of debris and dirt. Operate
the selector lever backwards and forwards to ensure
correct operation.
• Do not hose or submerge any part of the blower vac.
• Do not use solvents to clean the blower vac.
• Store the blower vac in a dry place, and out of reach
of children.
Power Cord Maintenance
If the supply cord needs replacing, the task must be car-
ried out by the manufacturer, the manufacturer's
agent, or an authorised service centre in order to avoid
a safety hazard.
GB-4
Werbung
Inhaltsverzeichnis
