Alphatronics K-19SB+ Bedienungsanleitung Seite 18

Note:
When the device is in operation, the LED indicator is not lit. When the device is in standby
mode, the LED indicator lights up blue.
Note: If the TV does not receive a VGA/HDMI signal after 1 minute, or if it does not receive a
video signal after 10 minutes, the TV automatically switches to standby. The standby LED then
lights up blue again.
K-19SB+ | K-22SB+ | K-24 SB+
Lower view
1 2 3 4
1 Input: Input DC 2 HDMI 1
2 HDMI 1
3 HDMI 2
4 AV in
K-19SB+ | K-22SB+ | K-24 SB+
Side view
1 2 3
1 Coaxial out
2 Mini YPbPr-In
34
5 6 7 8
5 Audio out
6 Headphones
7 DVB-S/S2 In (SAT antenna)
8 DVB-C/T2 In (cable connection/DVB-T antenna)
4
3 CI+ Slot
4 USB 1/ USB 2 Port
ENGLISH ENGLISH
Inserting the batteries
Replace the batteries as shown in the picture: 2 Batteries of type „AAA" are required
Attention:
1. Store batteries child-proof.
2. Never try to charge alkaline batteries, do not close them briefly and do not throw them
into the fire.
3. Always replace both batteries at the same time. Do not mix old and new batteries
or batteries of different design.
4. If the remote control is not used for a long time, please remove the batteries
to avoid leakage of acid.
Notes:
1. Do not drop the remote control or kick it.
2. Protect the remote control from water and moisture.
3. Do not use the remote control for other devices at the same time.
4. If the TV does not respond to the signals of the remote control,
please change the batteries first!
35