How To Use - AUDIOropa xepton-NX TR Bedienungsanleitung

3. How to use

3.1 Power ON / OFF
Use the ON/OFF switch to switch the device on. The LC-display will light up and the
current setup as well as the battery status are shown. The device is ready for use
after 3 seconds. After 8 seconds the display goes out. It lights up again when an
entry is made and goes out again after 8 seconds.
Use the ON/OFF switch again to switch the device off.
3.2 Channel group selection
Switch the device on and press the MODE-button for 3 seconds.
The symbol »GRP« in the display will blink. Select a channel of 0-7 by pressing the
» « and » « buttons. After the selection, wait for 3 seconds to set the selected
 
channel number.
Transmitters and receivers must be set to the same channel number if they are to
communicate with each other.
Please note: The symbols for a battery, as well as »MASTER« and »TALK« are always
visible in the display. These can be ignored.
3.3 Volume up / down
The volume can be adjusted through 6 levels from muted to maximum. On the powe-
red-up device, press the » « and » « buttons to adjust the volume as desired.
 
English 12