Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Post-dive procedures
1.
If connected, disconnect the DP1 hose.
2.
Pressurize the RS4 SCUBA.
3.
Rinse all parts of the RS4 SCUBA in clean water. If the equipment is very
dirty, use a brush and a neutral cleaning agent for extended cleaning.
4.
Close the cylinder valve.
5.
Press the purge button on the breathing valve to vent the regulator.
Venting may take as long as 30 seconds. The O-ring sealing between the
regulator and the cylinder valve may be damaged if it is removed when
there is pressure remaining.
6.
Remove the RS4 regulator from the cylinder.
7.
Allow all regulator parts to dry.
8.
Blow any moisture out of the cylinder valve by opening the valve and
allowing air to escape for 1 to 2 seconds.
WARNING
Blow-off noise and pressure surges may cause hearing
damage. Always use ear protectors when filling and
emptying air cylinder packs.
9.
Put the dust cover on the regulator connection nipple for protection.
10. If the equipment is faulty or damaged, it must be repaired or replaced by
an Interspiro certified service technician.
11. The equipment shall be thoroughly dried if it is to be stored in a bag/box for
more than a few hours.
20
RS4
Werbung
Inhaltsverzeichnis
