Operating Manual; Connecting The Keyboard; Adjusting The Volume - Cherry MX BOARD 5.0 Bedienungsanleitung

OPERATING MANUAL

CHERRY MX BOARD 5.0 – Corded Keyboard with XL Palm Rest
Congratulations ...
CHERRY has been developing and producing
innovative input systems for computers since
1967. You will now be able to feel the difference
EN
in quality, reliability and design with your new
favorite piece of equipment.
Always order original CHERRY equipment.
Your CHERRY MX BOARD 5.0 particularly
stands out due to the following features:
• Mechanical corded keyboard with patented
ergonomic solution and extra large,
individually adjustable palm rest
• Extremely sturdy and non-slip feet due to
duplicate design and rubber elements
• Aluminum frame
• Prepared for the CHERRY Performance Key
Kit (see 10.1 "Performance Key Kit")
• Precise response of the
legendary CHERRY MX key
modules, which you can still feel
after 50 million key strokes. The
modules are entirely developed and
manufactured in Germany.
• Dimmable, white key backlighting with
several light effects
• Win-Key lock: Windows buttons can be
disabled to prevent inadvertent operation
• Full N-Key Rollover: Simultaneous operation
of all keys without any key ghosting effects
For information on additional products, down-
loads, and much more, please visit
www.cherry.de.
10
1 Connecting the
keyboard
1 Run the cable in one of the ducts on the
underside of the keyboard so that it comes
out of the keyboard on the left, the middle or
the right.
2 Connect the keyboard to the USB port of the
PC/laptop.
The keyboard is ready to use without installing
any software. Regularly check that the
software is up to date (see 9.3 "Updating the
firmware").
2 Attaching the palm rest
1 Slide the palm rest close to the keyboard.
2 Align the palm rest with the center of the
keyboard.
3 Raise the front edge of the keyboard and the
rear edge of the palm rest together.
4 Lower the keyboard again by pressing it
gently downwards and in the direction of the
palm rest.
The holding tabs glide into the slots on the
bottom edge of the keyboard.
3 Adjust the inclination
of the keyboard and the
palm rest
The adjustable feet are located on the rear
edge of the keyboard and on both edges of the
palm rest. After you have attached the palm
rest, you can adjust the keyboard in 7
variations.
1 Fold the corresponding adjustable feet in or
out.
2 If necessary, reattach the palm rest.

4 Adjusting the volume

The symbols for adjusting the volume are
secondary functions of F1 to F3.
• To adjust the volume, press the FN key and
the appropriate key as shown in the table.
Example:
To switch the sound on or off, press the FN
key and F1 ( ).