Westfalia 316 156 300 107 Einbauanleitung Seite 12

Connecting the trailer control module
16. Fasten the trailer control module (Fig. 1/1) to the left-hand side of the luggage trunk using
some velcro tape. Make sure it is securely fastened!
17. Plug the 12-pin plug into the trailer control module.
18. Connect the brown wires with the eyelet to the vehicle's ground point (Fig. 1/3).
19. Using the 3-pin connector for the constant plus extension kit (Fig. 1/6), the functions
"Constant plus", "Charge lead" and "Ground for charge lead" can be retrofitted.
The constant plus extension kit is available from specialist shops under the Westfalia part no.
300 025 300 113.
Special information concerning vehicles with parking distance control (PDC)
On vehicles with PDC it is possible to deactivate the PDC for trailer operation.
20. The PDC controller is located behind the right-hand side panel in the luggage trunk.
Note
If you have any queries concerning the deactivation of the PDC system, please contact the
nearest garage.
If the control line is not used, insulate and secure the cable end.
Checking correct operation
21. Reconnect the ground of the vehicle's battery.
22. Check the trailer function with the help of a suitable test instrument (with load resistors) or
with the help of a trailer.
23. Secure all cables using cable ties.
24. Refit any parts removed for installation.
12 316 156 391 101 - 001 - 05/05
Installation Instructions:
Electrical System for Towing Hitch
Renault Laguna II Grandtour