First Installation; Batteries Installation; Rf Installation; With Receivers - Watts Industries BT-DRF-02 Benutzerhandbuch

1. Operating mode menu (active mode is framed).
Parameter number if "3" is displayed.
2.
3. Installation Parameter menu.
4. Type of sensor used and temperature displayed.
is
Regulation => Internal or external ambient sensor.
Regulation => Floor sensor.
Regulation => Internal sensor with Floor limitation.
Regulation => View of the outside temperature
5. Heating demand indication.
6. Low batteries indicator.
7. °C or °F unit indicator
Setting or measured temperature if "2" is displayed.
8.
9. Key lock indicator
10. RF indicator.
2

First Installation

This section will guide you to set up your thermostat for the
first time.
2.1

Batteries installation

- Open the two side's covers and Insert the 2 AAA Alkaline
supplied batteries (or remove the small protection sticker if
the batteries are already installed in the compartment)
- Close the two side's covers.
2.2

RF installation

2.2.1
- First of all to configure your thermostat with the receiver,
you must put your receiver in RF init mode. (Please refer
to the receiver leaflet for this, only the RF receivers of the
same range are compatibles)

With receivers

7
"2"