Watts Industries BT-DRF-02 Benutzerhandbuch Seite 14

To enter the value shown on the thermometer, use
the (-) or (+) keys to enter the real value. Then,
press (Ok) to confirm.
The message "Yes" should be displayed; the value
will be stored in the internal memory.
If you need to erase a calibration press on the
escape key (
The old value will be erased and the message "no"
will be displayed.
* Pay attention:
Only the heating element driven by the thermostat
must be used during the complete step of the
calibration.
05
OutC , AMbC , FlrC: Calibration of the
external wired probe
Same calibration method as described in
parameter
"04 AirC" above.
06
HG: Anti-freeze temperature used in Holiday mode
Default value 10°C.
Use the (-) or (+) keys to change the anti-freeze
setting temperature. Then press (Ok) to confirm.
08
Clr: Reset to Factory setting
Press and maintain (Ok) key during 10s to reset
Set points temperatures and user parameters in
this menu to factory default settings. User
programs will also be resetted.
* Pay attention:
Ensure you that you have all necessary elements
to re-setup your installation before to use this
function.
09
Displayed only if the BT-DRF-02 is linked with a
multizones receiver
CHA—
--: number of the linked zone
10
Software version
11
End: Exit the parameter's menu
Press (OK) key to exit installation parameter menu
and return to normal operation.
).
14