Eufab 21066 Bedienungsanleitung Seite 4

Mini compressor
OPERATING INSTRUCTIONS
Universal use, for example, for pumping up car,
motorcycle and bicycle tyres with car valve, sports balls
and small in atable toys.
• Maximum pressure: 17 bar / 250 psi
• With manometer • Including adapter
• Electricity supply via 12 V connection for vehicle socket
• Approximately 3 m connection cable
1. Manometer
2. Handle
3. Air slot
4. Cable holder (for winding)
5. 12 Volt adapter
WARNING
Read the operating instructions
through carefully prior to initial
use and observe all of the safety
notes! Not observing such may lead
to personal injury, damages to the
device or your property! Store the
original packaging, the receipt and
these instructions so that they may
be consulted at a later date! Prior to
initial use check the contents of the
packaging to ensure that they are
in perfect condition and complete!
4
!
1. Do not increase the air pressure above the
manufacturer recommendation!
2. Protect the compressor and its components from
damp!
3. Do not leave the operating compressor unattended!
4. Keep children away and do not permit children to
use this device!
5. Only use this product for the intended use!
6. Do not manipulate or disassemble the compressor!
7. If the compressor makes unusual noises or overhe-
ats, switch o immediately and allow at least 30
minutes to cool down. When operating for a longer
period of time, switch o after 10 minutes, leave to
cool for 30 minutes!
8. Check the compressor before use. Any damaged,
cracked or broken components should be
maintained by quali ed technicians only!
9. Never expose the compressor to frost, rain or
temperatures over 30° C or under – 30° C!
10. Never use on people or animals!
11. Make sure that the hose and cable are not exposed
to sharp edges, oil or objects that are too hot!
12. Warning! For your own safety, only use accessories
or replacement parts speci ed in the instructions or
that the manufacturer has recommended!
WARNING
These instructions are designed
to give information about the
functions and performance.
Keep
reference material for future use.
Before using the device for the rst
time, check the contents of the box
for integrity and completeness!
Pumping up car or bicycle tyres
1. Undo the 12 Volt cable.
2. Fit the car valve adapter to the valve.
3. Start the compressor by connecting the 12 Volt
adapter with the 12 Volt connection of your vehic-
le. Wait until the required tyre pressure has been
achieved.
4. Separate the 12 Volt connection from the vehicle
and remove the car valve adapter from the tyre
valve.
these instructions as