Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.4.5 Draining remaining water and cleaning the pump filter
The filter system in your machine prevents solid items such as buttons, coins and fabric fibers clogging the
pump impeller during discharge of washing water. Thus, the water will be discharged without any problem and
the service life of the pump will extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned whenever it is clogged or
in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house) and in case of freezing of
the water, water may have to be drained completely.
A
CAUTION:
CAUTION:
against any likely freezing.
CAUTION:
In order to clean the dirty filter and discharge the water:
1. Unplug the machine to cut off the supply power.
A
CAUTION:
after the water in the machine cools down.
2. Open the filter cap.
3. Some of our products have emergency draining hose and some does not have. Follow the steps below to
discharge the water.
Discharging the water when the product has an emergency draining hose:
4. Clean any residues inside the filter as well as fibers, if any, around the pump impeller region.
5. Install the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and then press the upper part to close.
30 / EN
Foreign substances left in the pump filter may damage your machine or may cause noise problem.
If the product is not being used, shut the tap shut, remove mains pipe and drain the water inside the machine
After each use, turn off the water tap to which the mains hose is connected.
Temperature of the water inside the machine may rise up to 90 ºC. To avoid burning risk, filter must be cleaned
If the filter cap is composed of two pieces, press
the tab on the filter cap downwards and pull the
piece out towards yourself.
a.
Pull the emergency draining hose out from its
seat
b.
Place a large container at the end of the hose.
Drain the water into the container by pulling
out the plug at the end of the hose. When the
container is full, block the inlet of the hose
by replacing the plug. After the container is
emptied, repeat the above procedure to drain the
water in the machine completely.
c.
When draining of water is finished, close the end
by the plug again and fix the hose in its place.
d.
Turn the pump filter to take it out.
Washing Machine / User's Manual
Werbung
