Operation; Maintenance - REV Ritter FLEX POWER 10 Montage- Und Bedienungsanleitung

SCOPE OF DELIVERY
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• Product
• Instructions
• USB charging cable
TECHNICAL DATA
• Output: 2x5W LED
• Illuminant: SMD LED´s
• Luminous flux: 2x500lm
• Colour temperature: 6500K
• Colour rendering index (Ra/CRI): ≥ 70
• Energy efficiency class: A+
• LED service life: 30000h
• Beam angle: 80°
• IP protection class: IP20
• Protection class: III (S5)
• Ambient temperature: -20°C – 50°C
• Dimensions W x H x D: folded: 200 x 50 x 140mm; folded out: 230 x 200 x 50mm
• Weight: 572g
• Battery: 3.7V / 5000mAh / lithium polymer battery (955465) / 18.5Wh
• USB: Micro IN 5VDC, max. 1A; USB OUT 5VDC, max. 1A

OPERATION

• Load: Before (first) use, fully charge the product until the battery indicator lights up completely
• Charging time: 6 hours (depending on selected USB power supply)
• Duration: 4 hours (950lm) / 7 hours (500lm)
• 1x press: both sides (950lm)
• 2x press: one side (500lm)
• 3x press: opposite side (500lm)
• 4x press: From
CLEANING
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!

MAINTENANCE

• Remove all dirt from the housing or protective panel immediately, as this can lead to overheating.
• The light source of this luminaire is not replaceable; if the light source has reached the end of its service life, the
entire luminaire must be replaced.
WEEE DISPOSAL INFORMATION
According to the European regulations, used electrical and electronic equipment may no longer be put out into
unsorted rubbish. The symbol on the wheeled rubbish bin points out the necessity for separated collection. Help
us to protect the environment and ensure that this unit is put out in the appropriate systems for separate collection
once you do not use it any longer. DIRECTIVE OF THE EUOROPEAN PARLIAMENT AND COUNCIL of 4th July 2012
concerning used electrical and electronic equipment. (S6)
GB
10