Replacing The Battery; Troubleshooting - Reflecta 86801 Bedienungsanleitung

Replacing the battery

(4) Open the back board of the emitter with the screwdriver
(5) Take out the old battery and then place the new one in (12V23A Battery)
(6) Close the back board well with the screw (please take the old battery in the
appointed place)

Troubleshooting

The LED light of the emitter is off or weak ->
Please check the battery of the receiver
The LED light of the emitter is on, but the command cannot be sent ->
Please check the connection and the receiver or check the programm setting
The LED lights of the emitter and receiver work well but the motor does
not work ->
Please check the connection and the main power supply of the motor or
check the main power supply.
reflecta gmbh
Merkurstrasse 8
72184 Eutingen i.G.
Germany
www.reflecta.de
Seite 6 von 6 04.03.2016 reflecta gmbh