Anti-Drip System - Bosch TDA 56-Serie Gebrauchsanleitung

r
Downloaded from www.Manualslib.com
Shot of Steam
Set the temperature control dial to at
least the "•••" position
Interval between shots of steam should
be 5 seconds.
Vertical Steam
Do not iron clothing while it is being
worn!
Never direct the steam at persons or
animals!
Interval between shots should be 5
seconds.
Wait 10 seconds after each 4 shot cycle.
Multiple descaling system (7)
Depending on the model, this range
is equipped with the
(=component 1 + 2 + 3).
1. self-clean
Each time you use the steam regulator,
the "self-clean" system cleans the
mechanism of scale deposits.
2. Calc'nclean
The "Calc'nclean" function helps to
remove scale particles out of the steam
chamber. Use this function approximately
every 2 weeks, if the water in your area
is very hard.
1. Unplug the iron from the mains
socket, set the steam regulator to the
position and fill the water tank with
water.
2. Set the temperature selector to the
"max" position and plug in the iron.
3. After the necessary warm-up period,
the pilot light goes out. Then, unplug
the iron.
4. Hold the iron over a sink. Press the
"clean" button and gently shake the
iron. Boiling water and steam will
come out, carrying scale or deposits
that might be there.
5. When the iron stops dripping, release
the button, plug the iron in and heat it
up again until the remaining water has
evaporated.
6. Repeat the process if the iron still
contains impurities.
manuals search engine
(5)
3. anti-calc
The "anti-calc" cartridge has been
designed to reduce the build-up of scale
produced during steam ironing, helping
to extend the useful life of your iron.
Nevertheless the "anti-calc" cartridge
cannot remove all of the scale that is
(6)
produced naturally over time.
"Secure" auto shut-off
function
(Depending on model)
The "Secure" auto shut-off function
switches off the iron when it is left
unattended, thus increasing security
and saving energy. After plugging in the
appliance, this function will be inactive
for the first two minutes in order to give
"AntiCalc"
the appliance time to reach the set
temperature.
Alter such time, if the iron is not moved for
8 minutes while in the upright position or
30 seconds while resting on its soleplate
or on its side, then the safety circuit will
switch the appliance off automatically
and the pilot light will start flashing.
To reconnect the iron, just move it about
gently.

Anti-drip system

(Depending on model)
If the temperature is set too low, the
steam is automatically switched off to
avoid dripping.
Fabric-protection soleplate
cover / blanket
(Depending on the model)
The fabric-protection is used for steam-
ironing delicate garments at maximum
temperature without damaging them.
Use of the protector also does away with
the need for a cloth to prevent shine on
dark materials.
It is advisable to first iron a small section
on the inside of the garment to see if it
is suitable.
To attach the fabric protector to the iron,
place the tip of the iron into the end of
the fabric protector and press the rear
of the protector upward until you hear a
click. To release the fabric protector, pull
down on the clip at the rear and remove
the iron.
en
(8)
(9)
(10)
11