Ayce YDZ-30D/S1 Gebrauchsanweisung Seite 31

Symptoms Possible reasons
Does power plug fall?
Is the water tank full of water? (the
The dehumidifier wa-ter tank is full of water or is
does not run placed at incorrect position)
The ambient temperature is lower
than 5 or higher than 32 ºC
Is the room temperature or
The
humidity too low?
dehumidification
func-tion is not
Are the air outlet and inlet blocked?
effective
Air is not blown
Is the air strainer blocked?
out
Is the dehumidifier placed
improperly so that it is inclined or
unstable?
Noise is
abnormal during
Is the air strainer blocked?
operation
There is "tittering" sound
Connection of drainage pipe
becomes loose
Water leaks
Drainage system is blocked
The ambient temperature is low,
Frosting occurs and it is in the state waiting for
defrost.
FL on the LED
Serbatoio acqua pieno
display
E1 on the LED Anomalie del sensore della
display temperatura del tubo.
E2 on the LED Anomalie del sensore della
display temperatura ambiente.
P1 on the LED
Sbrinamento
display
CL on the LED
Asciugatura interna
display
Solutions
Insert power plug into socket.
Drain water from the water tank,
and then install the water tank
again.
Normal phenomenon
In dry season the dehumidification
ability will reduce.
Clean up the objects blocking the
air outlet and inlet.
Clean the air strainer according to
the above method.
Please place the dehumidifier in
smooth place.
Clean the air strainer according to
the above method.
The flowing sound of refrigerant,
which is a normal phenomenon.
Fasten drainage pipe.
Remove obstacles and straighten
out water pipe.
It is a normal phenomenon, and the
dehumidifier has the automatic de-
frosting function.
Empty the water tank
Check the pipe temperature sensor
and related circuitry.
Check the room temperature sensor
and related circuitry
Wait for defrosting, the func-tion
will restart automatical-ly.
It's normal
60 | 61 GB