Putting Into Operation - Memmert HPPeco Kurzanleitung

DELIVERY, TRANSPORT AND SETTING UP
WARNING
Condensation might cause a short circuit. After transport or storage
at high humidity conditions, the appliance shall be stored unpacked at
normal conditions for at least 24 hours. During this period of time the
appliance shall not be connected to the power supply.
CAUTION
You could be injured due to the weight of the device if you try to lift
it alone. Observe the required number of people to carry equipment.
Larger equipment must not be carried, but only transported with a lift
truck or forklift.
≤ 75 L
Setting up
WARNING
Due to its centre of gravity, the appliance can fall over to the front and
injure you or other people. Always attach the appliance to a wall with
the tilt protection.
The distance between the wall and the rear of the appliance must be at least 15 cm.
The clearance from the ceiling must not be less than 20 cm and the side clearance
from walls or nearby appliances must not be less than 5 cm. Sufficient air circulation
in the vicinity of the appliance must be guaranteed at all times.
≥ 15 cm
≤ 260 L > 260 L
CAUTION
The appliance could fall over and seriously injure you. Never tilt the ap-
pliance and transport it in upright position and without load only (except
for standard accessories such as steel grids or shelves). Appliances
with castors always have to be moved by two people.
CAUTION
You may get your hands or feet squashed when transporting and in-
stalling the appliance. Wear protective gloves and safety boots. When
grasping the bottom of the appliance, grasp it only on the sides.

Putting into operation

NOTICE
The first time the appliance is operated, it must not be left unattended until it has
reached the steady state.
Observe the country-specific regulations when making connections. Observe the con-
nection and power ratings (see nameplate and Technical data). Make sure to establish
a safe PE conductor connection.
Lay the power cable so that
no one can trip over it;
X
it does not come into contact with any hot parts;
X
it is always accessible and within reach so it can be disconnected quickly in the
X
event of failure or emergencies.
5