SuperFish PondECO Plus RC 15000 Gebrauchsanweisung Seite 5

Safety
Always follow the safety instructions below for safe use of the device. Failure to follow these instructions may
endanger persons or the environment.
• This device must be protected by an earth leakage relay breaker with a leakage current of a maximum of
30mA.
• Ensure the voltage shown on the label matches the mains supply voltage.
• This device must be connected to a socket which is earthed.
• Protect the socket and plug against moisture. Use a drip loop to ensure water cannot reach the socket and
plug connection of the receiver via the cord (see Fig. A).
• The receiver must be installed in a dry place, with a minimum 2 metre clearing from the pond.
• Don't use the product if the device, cord or plug is damaged. Return the device to your dealer for repair or
recycling. A damaged cord or plug cannot be replaced.
• Be careful with the combination of water and electricity. Do not operate with wet hands. Dry hands
before carrying out maintenance.
• Never use the device when there are people in the water.
• Always switch off all devices at the mains supply before maintenance.
• Do not move or lift the device out of the water by the cord, only lift the device by the handle.
• This device can be used by children aged from 8 years and above, persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge, if they have been given supervision or
instructions concerning the use of the device in a safe way and understand the hazards involved. Children
shall not play with the device. Cleaning and maintenance of the device shall not be done by children
without supervision.
• Modifications to the device may affect the safety. The warranty will also expire.
Function
The PondECO Plus RC is an electronic pond pump for use with filters, skimmers, waterfalls and water ornaments. The pump is
equipped with a remote control and receiver which regulate the pump capacity and stepped head.
Run Dry Protection
The pump is equipped with a dry-running safety device, which is especially important when used inline. It is important that water
can always be pumped around. If there is no water flow for 10 seconds, the pump will automatically stop and then restart after 10
seconds. If there is still no water flow, the pump will stop and restart again. This cycle is repeated 5 times, after which the pump stops
completely. You can restart the pump when the water supply is restored. Pull the plug out of the socket, wait 60 seconds and plug it
in again. The pump will now start up and pump water around.
Thermal overload protection
The pump has a thermal overload protection in case the motor overheats, the pump switches off automatically. After a cooling down
time of 15 to 20 minutes, the pump automatically switches on again. In order to prevent damage to the pump, it is essential to
investigate the cause of the overheating and resolve the issue. Damage caused by overheating is not covered by the warranty.
5