Südwind Ambientika Eco Handbuch Für Installation Und Wartung Seite 46

1) ASSEMBLY
After having identified the area intended to the product installation, mark the center of the hole to
be made on the wall.
Make sure that, with respect to the center of the hole for the recessed tube, there is free space on
the internal and external walls for a radius of 15 cm from the center - these correspond to the
volume of the product. Make sure, therefore, that within this area, there is no interference with
non-removable walls and objects.
The diameter of hole to be made is Ø160mm.
The hole made in the wall must be a through one and with an inclination of 1 ° - 2 ° outwards. In
order to be able to use the recessed tube supplied, the wall thickness must not exceed
500mm. The wall intended to the product installation must not be less than 250mm thick. Once the
through hole in the wall is formed, place the recessed tube within (6).
Make sure that the length of the recessed tube (6) is equal to the wall thickness.
The tube must end flush with the surfaces of the internal and external walls.
7