Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installing the compact alarm (radio and standard versions)
1. Remove the compact alarm from the packaging. Open the external
2. Drill the holes accordingly and the hole for the supply cable.
3. Now pull the cable from behind through the cable hole into the
4. Screw the compact alarm to the wall.
5. When tightening the screws, make sure that the rear sabotage
6. Connect the individual wires of the connection cable to the clamps
7. Optionally, you can insert a 1kOhm resistor between [+12V DC]
8. Connect the battery to the respective clamps. A short signal tone
9. Set the jumper (14) to the right position for the diagnostic LEDs
Note:
When you close the casing lid, a long tone sounds. The compact alarm
then runs a self-test. If the self-test is successful, the LEDs start to flash
alternately. Opening the casing now triggers a tamper alarm.
Downloaded from
www.Manualslib.com
casing and use it to mark the four drill holes for the wall fixings and
a hole for the cable feed.
compact alarm.
contact is correctly pressed into place.
(wired version) as described in the connector overview, or plug in
the RJ11 plug (radio version).
and [Siren Trig], as well as between [+12 DC] and [Strobe Trig] in
order to obtain a defined potential at the control inputs for the idle
state. This wiring method reduces disturbances to the feed lines,
thus helping to avoid accidental alarm triggering.
sounds.
(active or inactive), and close the casing.
manuals search engine
16
Werbung
