Safety Instructions; Limited Warranty - Behringer CHROMATIC TUNER TU300 Handbuch

2 CHROMATIC TUNER TU300
Press the STREAM/CENT button to switch between the LED
(5)
display modes (see chapter "Operations").
Press the MODE button to select the tuning mode (see chapter
(6)
"Operations").
Use the footswitch to activate/deactivate the tuner.
(7)
Connect your guitar or bass to the ¼" TS IN connector.
(8)
Connect your amp or another stompbox to the ¼" TS OUT
(9)
connector. When the tuner is activated (footswitch pressed)
the output is muted. This way, you can silently tune your guitar
or bass.
The ¼" TS BYPASS connector always sends a signal to your amp
(10)
independently of the footswitch position.
Use the DC IN connection at the right side of the unit to plug in a 9 V
power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen and
remove the pedal cover. Be careful not to scratch the unit.nd remove the
pedal cover. Be careful not to scratch the unit.
◊ ◊
The TU300 is powered as soon as you insert a plug into
the INPUT. The battery is "disconnected" when the plug is
removed. For this reason, the TU300 has no on/off switch.
To extend battery life, always disconnect the input when
the unit is not in use.
The SERIAL NUMBER is located at the bottom.

2. Safety Instructions

Do not use near water, or install near heat sources. Use only authorized
attachments/accessories. Do not service product yourself. Contact our
qualified servicing personnel for servicing or repairs, especially when
power supply cord or plug is damaged.

3. Limited Warranty

For the applicable warranty terms and conditions and additional
information regarding Music Tribe's Limited Warranty, please see
complete details online at musictribe.com/warranty.