Backlight - Calypso Watches IKMK5813M Betriebsanleitung

I
ENGLISH INSTRUCTION MANUAL
ICONS
Cronómetro
Doble huso horario
Alarma
Resistencia al agua de 100 m
Retroiluminación EL
Señal horaria
Batería (CR1616)
DISPLAY
The screen shown in below:
Day of week
Hour

BACKLIGHT

The backlight that uses an EL (electro-luminescent) cause
the display to glow fer easy reading in !he dark.
Use EL BACKLIGHT
• In any mode, press "C" to iluminate the display about 3
seconds
ALARM
Alarm and Chime
• In the alarm mode, press "D" to en/off the alarm and chime in the fellowing
sequences: Alarm & Chime off - Alarm on -Chime on Alarm & Chime en.
Alarm Time Setting
1. In the alarm mode, press "A" the hour to flash, the indicator "
(flashing indicated in set mode) .
2. Press "D" to increase !he hour, press and hold to in crease al high speed.
3. Press "B" lo select lhe minutes.
4. Press "D" to increase !he minutes, press and hold to increase al high
speed.
5. Press "A" to exit the set state, alter you set.
• The alarm sounds al the preset time each day fer about 60 seconds, press
any bullen to break it.
DUAL TIME
Dual Time Setting
1. In the dual time mode, press "A" the hour to Flash (Flashing indicated in set mode).
2. Press "D" to in crease The hour, press and hold to increase al high speed.
3. Press "B" to select the minutes;.
4. Press "D" to change the minutes (press once change 30 minutes).
5. Press "A" to exit the set state, alter you set.
By virtue of the regulations pursuant to the handling of waste products deriving from electronic and electrical equipment, end of lifecycle watch making
products must be selectively collected for processing. You may therefore dispose of your quartz watch making products at any of our retail outlets or any other
authorized collection point. The selective collection, processing, rating and recycling of these products helps contribute to safeguarding the environment and
protecting our health.
BUTTONS
The operation el bullo ns are indicated by
using the letters shown in the illustration.
A -- Reset
B -- Mode
C -- EL backlight
D -- Start / Stop
Minutes
Seconds
" appear
IKMK5813M
MODE SELECTION
Press "B" to change mode to mode in the following Sequence:
Timekeeping Mode-Alarm Mode Stopwatch Mode - Dual Time Mode.
TIMEKEEPING
• 12/24H Format;
• Hour, Minutes,
Seconds, Day of week;
• Build in Date.
STOPWATCH
• 1/100 second unit.
• Measuring range:
0'00"00 - 23:59'59".
TIMEKEEPING
Time Setting
1. n the timekeeping mode,
press and hold "A" until
the seconds to flash
(flashing indicated in set
mode).
2. Press "D" to reset the
seconds.
3. Press "B" change to the
next selection.
4. Press "D" to increase the
number, press and hold to
increase al high speed.
STOPWATCH
A Lap Time
1. In the stopwatch mode, press "D" to start
the stopwatch.
2. To stop the stopwatch by pressing "D"
again.
3. Press "A" to reset the stopwatch.
ATENCIÓN
1. Never try to open the case or remove its back cover.
2. Do not operate buttons under water.
3. Should moisture appear inside the watch,have it checked immedialely by your dealer.
Olherwise it can cause erosion el the metal parts el !he watch.
4. Though !he watch is designed to wilhstand normal use, you should avo id rough use or
dropping lhe watch.
5. Avoid exposing !he watch to temperature extremes.
6. Wipe the watch wilh dry, Sol! clolh only. Avoid all owing it to come into direct contact with
chemical materials, which can cause deterioration of the plastic parts of the watch.
7. Avoid to wear the watch in electromagnetic, static conditions.
ALARM
• Hourly time signal;
• The alarm sounds at
the present time each
day.
DUAL TIME
• The time fer other time
zone.
5. Re peal step 3 and 4, the
selection in the fellowing
sequence: Seconds - Hour -
Minutes - Month - Date - Day
of week - 12/24H Format.
6. Press "A" to exit the set state,
alter you set.
Calendar
• In the timekeeping mode, press and hold "D"
to display: Month, Date
Split Time
1. In the stopwatch mode, press "D" to start
the stopwatch.
2. Press "A" to display the split time,
stopwatch timing continues internally.
3. Press "A" lo clear !he split time and to
continue time measurement.
4. Reapeat step 2 and 3, you can measure
the multi split time.
5. Press "D" to stop the stopwatch.
P/N:MSA-94510-0E0G