Basic Parameter; Protocol-Type; Output Interface; Firmware-Update Enabled - TR-Electronic HID V5 Installationsanleitung

Programming

5.3 Basic parameter

5.3.1 Protocol-Type

5.3.2 Output Interface

5.3.3 Firmware-Update enabled

5.3.4 Hardware-Interface

5.3.5 Low-Address HID-Device

5.3.6 LJU-Preset

 TR-Electronic GmbH 2014, All Rights Reserved
Page 28 of 32
Downloaded from www.Manualslib.com
Selection Description
The measuring system to be programmed must be
TRWinProg
TRWinProg compatible.
Serial Line only for service purposes
Serial
for internal logging
only listening
SSI-Master In a SSI network the adapter can be used as a master.
SSI-Passive In a SSI network the adapter can be used passively.
The measuring system to be programmed must be LJU
LJU-Protocol
compatible.
Selection Description
RS485 The transmission is established as RS485 interface.
K-Line or The transmission is established as K-Line or CAN
CAN-Driver interface.
For the initialization of a firmware update of the adapter the numbers "12345" can be
entered here. "0" means that no firmware update is permitted at the moment.
Shows which interfaces are supported by the respective adapter variant. The
hardware variants are indicated by different article numbers, see "Hardware versions"
on page 23.
By means of this attribute the low byte of the HID device addresses can be set
manually for adapter identification. For the adapters attached to the PC the address
range from 0x61 to 0x67 is available. At the PC each address can be set only once, 7
adapters per PC are possible therefore.
Manufacturer specific function for the LJU interface.
manuals search engine
TR - E - TI - DGB - 0103 - 05
Default
X
Default
X
Printed in the Federal Republic of Germany
06/21/2016