Programming; Default Settings; Requirements - TR-Electronic HID V5 Installationsanleitung

Programming

5 Programming

5.1 Default settings

5.2 Requirements

 TR-Electronic GmbH 2014, All Rights Reserved
Page 26 of 32
Downloaded from www.Manualslib.com
In case of delivery the following parameters are preset:
● Protocol-Type:
● Output Interface
● Baud rate:
If the PC adapter shall be operated under TRWinProg, no programming of the PC
adapter is necessary.
The PC adapter can be programmed only about the programming software
TRWinProg ex version 5.11 (DLL3.1.6). Therefore, TRWinProg must already be
installed on the PC for programming. If this is not the case, the program and the
program documentation can be downloaded from the internet page: Download.
So that the PC adapter is detected by TRWinProg, no Plug Power Supply Unit
and no measuring system at the PC adapter must be connected. Only a
connection about the USB-cable to the PC must be established!
manuals search engine
TRWinProg
RS485
9600 Baud
TR - E - TI - DGB - 0103 - 05
Printed in the Federal Republic of Germany
06/21/2016