Basic Settings - TR-Electronic HID V5 Installationsanleitung

5.2.1 Basic settings

Printed in the Federal Republic of Germany
06/21/2016
Downloaded from www.Manualslib.com
 Start TRWinProg on the PC and select the menu "Extra --> Global".
 Select the button
HID devices and the serial COM ports.
 Choose the "HID-Device" with a double click on the left mouse button. The HID
device address is displayed then in the window. If the depending HID device is
already active, it can't be selected again. In this case, this window must be closed
and the window "Global" must be opened again.
 In the drop-down menu "Comm-DLL : TRWPDLL", the selection „HID-Device"
must be set automatically.
 On top of the window at the menu "USB-HID" it can be selected which HID-device
shall be accessed.
 Maximum 7 adapters can be connected at a PC. Therefore the HID device
addresses from 0xA361 to 0xA367 are available. The HID device address can be
changed afterwards about the parameter "Low-Address HID-Device", see page
28.
 To save the settings you have to press the „OK" button.
 With the „Offline <--> Online" button
connected.
manuals search engine
right hand in the window at "USB-HID" to show the available
TR - E - TI - DGB - 0103 - 05
the PC-Adapter now can be
 TR-Electronic GmbH 2014, All Rights Reserved
Page 27 of 32