Troubleshooting - True Systems P-Solo Ribbon Bedienungsanleitung

TROUBLESHOOTING

No signal output.
Main power switch is on, but no LED's are
illuminated.
• Check AC power source and cord.
• Check fuses (pull fuse drawer under
power cord inlet)
>> Disconnect Mains before!
No signal output.
Main power switch is on and some LED's
are illuminated.
• Check status of phantom power.
• Check continuity of mic and electric
instrument cables.
• Check continuity of output cables.
Output signal is distorted.
Outputs are connected for balanced op-
eration.
• Make sure gain is adjusted so that the
OL indicator does not activate during
the audio program.
• Make sure the high output capability
of this unit is not overloading the de-
vice or monitoring system to which it is
connected set GAIN selector to match
capability of device or monitoring
system, then adjust gain control ac-
cording to indications on the Level
Indicator LED's.
• Check continuity of output cable.
• Make sure outputs are not connected
to a load impedance of less than 600
ohms.
TRUE systems
Downloaded from www.Manualslib.com manuals search engine
30
Output signal is distorted.
Outputs are connected for unbalanced
operation.
• Make sure the minus (3) output signal
pins are connected to the screen (1)
and not left unconnected. See "Out-
put Cable Connection" section.
• Check troubleshooting tips for bal-
anced operation (above).
Electric instrument
connected to a Direct Input does not
produce a signal or signal is distorted.
• Check continuity of electric instru-
ment cables.
• Check the batteries or AC power
source of any "foot pedal" effects
processors connected to the Direct
Input.
• Make sure that the instrument cables
have standard tipsleeve 1/4" phone
plugs. DO NOT use TRS plugs.
SOLO