Mic Input - True Systems P-Solo Ribbon Bedienungsanleitung

CONNECTORS Rear Side
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OVRIR
TRUE Systems
P - SOLO Ribbon
RoHS
2002/95/EC
e
1
SUNRISE ENGINEERING AND DESIGN INC.
TUCSON, ARIZONA U.S.A.
TRUE systems
Downloaded from www.Manualslib.com
BALANCED
9W
115 V
115/230 V
For continued protection
against re, replace only
with same type fuse:
115 T 125 mA L, 250V
230 T 63 mA L, 250V
Consult Operation Manual
for voltage selection
procedure.
manuals search engine
24
Balanced (XLR)

MIC Input

MIC
IN
Balanced (XLR)
LINE Output
OUT
Balanced (TRS)
LINE Output
Voltage Setup (inside)
50-60 Hz
Fuse Drawer
Main Power Switch
Mains Power Connector
Microphone Connection: Microphone
connection is made to an XLR MIC IN
receptacle on the rear panel. The wiring
configuration used for the microphone
connectors on the
P-SOLO
• Pin 2 is positive (+)
• Pin 3 is negative (-)
• Pin 1 is screen (GND)
Do not attempt to connect unbalanced
microphones to the P-SOLO
is not intended to operate with this type
of microphone.
SOLO
is:
. It