True Systems P-SOLO Ribbon Bedienungsanleitung Seite 25

CAUTION: We recommend that you avoid
"hot-patching" the microphone input if
using a patch bay at the microphone in-
put of the P-SOLO
down the gain prior to connecting or
repatching a microphone input routed
through a patch bay. Failure to do so
may result in transients that can damage
the P-SOLO
is connected to its outputs - not to men-
tion your ears!
Output Cable Connection
For ease of connection, two styles of
BALANCED OUT connector, XLR and
TRS, are provided. Both connector
types are electrically equivalent and
may be used simultaneously to connect
to Line Inputs on mixing consoles,
recorders, etc. If both outputs are used,
care should be taken to avoid system
ground loops. See "Troubleshooting"
section for tips on eliminating hum
caused by grounding problems.
The TRS and XLR output connectors are
not electronically isolated. Therefore, if
you connect either one of the output
connectors to an unbalanced input, the
other connector will automatically be
unbalanced.
Downloaded from www.Manualslib.com
. Please turn
or equipment that
SOLO
manuals search engine
CONNECTORS Rear Side
25
When connecting an output of the P-
SOLO to an unbalanced input,
you must connect the negative signal pin
(pin 3 of the XLR or "ring" of the TRS) to the
shield. Failure to do this will result in au-
dible distortion. The wiring configuration
used for the output connectors on the
P-SOLO
For XLR:
• Pin 2 is positive (+)
• Pin 3 is negative (-)
• Pin 1 is screen (GND)
For TRS:
• Tip is positive (+)
• Ring is negative (-)
• Sleeve is screen (GND)
is:
TRUE systems
E