Instruction Manual / International Guarantee - Chronos Manufactures Mathieu Legrand MLG-1003 Master Bedienungsanleitung

EN
MLG-1003 Master
Movement: Quartz Swiss made
ATTENTION: Never set the date
between 9pm and Midnight, as
there is then the chance that the
date will not change the next day.
Date and Time Settings
Pull out the crown to Position 1. Turn it in a clockwise direction until the
correct date appears. Pull the crown further out to Position 2 and twist it
to set the correct time. Then carefully push the crown back in.
Using the Chronograph
Basic Function
Press button A, to start or stop the Chronograph. You can ascertain the
timer by setting the Chronograph minute hand to 9,5. Press button B to
reset the Chronograph second-timer and the Chronograph minute-timer.
Additional Timekeeping
Press button A to start and stop the Chronograph. Press button A once
again to resume the time and once more to stop it. The additional timer
can be continued in this manner. Press button B to reset the central
Chronograph second hand and minute hand.
Instruction manual
Split-time measurement
Press button A to start the Chronograph. Press button B to display the
split-time (The timer still runs in the background). Press button B to make
up the measuring time (The 2 Chronograph hands quickly move forward
to catch up the time which has elapsed). Press button A to stop the
Chronograph and to display the end time. Press button B to reset the
Chronograph hands.
Chronograph controls
To ensure that the Chronograph hands return to their 0-Position, a com-
plete initialisation process must be competed once the watch hands
have been reset. Every counter must be re-adjusted once. For this, the
crown should be pulled out to Position 2, simultaneously press down
button A and B for at least 2 seconds. Then position the Chronograph
second hand to 0, whist pressing button A, briefly to adjust step-by-step
and hold it down longer to move the hand in a continual movement.
While button B is pressed, the Chronograph minute hand can be chan-
ged in the same way. Then the crown should be pushed back in to the
original position of 0.
10