Changing The Blade; Removing The Blade; Trouble Shooting - WOLFF 76859 Original Bedienungsanleitung

5.2 Use
Position the machine with roller (D) align on seam.
Locate guide roller (E) in the joint also.
The speed of the grooving blade can be varied with wheel (G)
Start motor by flipping switch (F).
Push down slowly to the required grooving depth.
Push the machine forward slowly.
The speed at which the groove can be done will vary
according to the material being cut as well as the depth.

6.0 Changing the blade

6.1 Removing the blade

Remove the upper thumb screw (H) of the blade cover.
Loosen the thumb screw (I) at the bottom of the blade cover.
Remove blade cover upwards.and press spindle lock.
Loosen tension screw (K) with the fork wrench supplied.
It is a left-handed thread!
Remove flange.
and
new blade.
6.2. Fitting a new groove blade
Fit only a genuine replacement blade:
#076860 HM-Grooving blade 6 mm straight
#036275 Original grooving blade 3,3 mm semicircle
#013461 Grooving blade Combi 5 mm
#013460 Diamand grooving blade 3,8 mm elliptical
The fitting of the new blade has to be done the other way.
Insert new blade with attention to moving direction.
Put back on the flange and Re-tighten tension screw.

7.0 Trouble shooting

Trouble Eventual cause
Machine does not work Power supply
disconnected
Blown fuse
Defective cable or plug
Undue force necessary Blade is blunt
to achieve a groove
Excessive vibration Motor worn
Tooth of the blade
broken
Bad grooving Guirs clogged
REPARATURFRÄSE 230 V , D, F, A
01/2015
blade and clean flange prior to re-fitting a
Elimination
Have machine
repaired by a qualified
electrician
resp. change parts
Change blade
Return machine for
service and/or repair,
change blade
Clean rollers
Make sure that the machine locks into its upper rest when
you release the handle. Other-wise you might cause an
accident and eventually damage the blade. Always use a
new, sharp blade. Blunt blades will give unsatisfactory
results and will put stress on the machine.
I K L H
Always disconnect the power supply before changing
the blade! Unintended starting of the machine may
cause injury.
Under no circumstances should the machine be operated
without the cover in place.
#76859R
J
11