Remington IPL6750 i-Light Prestige Bedienungsanleitung Seite 12

ENGLISH
, PREPARE THE i-LIGHT FOR USE
• Unwrap the hand piece cord from the i-LIGHT base and rest the hand piece back on the base unit.
• Ensure the power switch on the base unit is OFF.
• Connect the power cord to the i-LIGHT base unit at the power inlet.
• Connect the power cord to the wall outlet. Turn the power switch ON (Fig. 5).
, SELECTING THE ENERGY LEVEL
• The i-LIGHT is equipped with 5 energy levels. Level 1 is the lowest setting and level 5 is the highest
setting.
, TIP: For the most effective results, always use the highest energy level that does not cause discomfort
on the skin.
• To determine the energy level being used, observe the number of lights illuminated on the Energy
Level Display (Fig. 6).
• Your i-LIGHT will automatically be set to Energy Level 1 each time the device is powered ON. To
change the level, press the Energy Level Selection Button.
, TEST THE i-LIGHT ON YOUR SKIN
, Before your first full treatment, test the i-LIGHT on a small patch of skin and wait 24 hours to
ensure there are no adverse reactions.
• Start at energy level 1.
1 Place the i-LIGHT hand piece against your skin so the Flash Window is flush with the skin surface.
2 Ensure the Skin Contact Sensors are fully engaged and the Bulb Status Indicator Display is illuminated
green (Fig. 7).
12
Fig. 5
Fig. 6