Continuity Measurement; Replacing Battery - Bgs Technic 8890 Bedienungsanleitung

Voltage Measurement
1. Turn off the vehicle power; connect the tester as Fig. 4.
2. Press the "POWER" button to switch on the power.
3. Press "MODE" button to change the function to voltage
measurement mode. The letter "V" shall display on the LCD. User
can start the measurement.
4. During the measurement, if the voltage is less than 1 volt, no
voltage will be displayed.
5. During the measurement, if the measured polarity is reversed,
"ERR" will be displayed, and buzzer will buzz. Please reverse the
test probe and do the measurement again.

Continuity Measurement

1. Same step as voltage measurement 1 - 3.
2. If the resistance is less than 1 kohm, "ERR" will be displayed, and
buzzer will buzz. This indicates that it's a continue circuit.
MAINTANCE

Replacing Battery

When appear on the LCD. It means that battery needs to be replaced. Please use new 9V
battery. Follow the instruction of Fig.5 and Fig.6.
Caution
Please remove all the connection before replacing the battery.
Please confirm the battery is in correct polarity before replacing it.
Please dispose old battery according to local authority guideline.
Fig. 5
SW-Stahl und Werkzeugvertriebs GmbH
L e v e k r u s r e t S a r s s e 6 5
D 4 - 2 8 9 7 R e m s c h e d i
Black
Tel. +49 (0) 2191 / 46438-0
F ax +49 (0) 2191 / 46438-40
- E M a : l i n i o f @ s w s a t l h d . e
Red
Fig. 4
Fig. 6