Network Settings; Network Wizard - Kenwood CR-ST100S Bedienungsanleitung

15.2 Network settings

15.2.1 Network wizard

The network wizard helps to connect the radio to the Internet. To call it up, please proceed as follows:
Select the "Network" in the "System Settings" menu and then confirm "Network wizard". The
radio now starts a search for available WLAN connections and then lists them. The various networks
can be selected using the <UP> or <DOWN> buttons and the <NAVIGATE> knob. At the end of the
list there is the option to select "[New search]" or "[Manual config]".
15.2.2 Wireless network connection (WLAN)
Depending on the network, you have several options to choose from to connect to the network. Net-
works that support a WPS connection (Wi-Fi Protected Setup) are identified in the list by the prece-
ding designation"[WPS ...]". Other connections are open networks or connections that are protected
by the PSK method = pre-shared key (previously agreed key).
Note: An active network connection is indicated by a white symbol at the bottom right of the display.
If no connection is active, this symbol is crossed out in red.
15.2.3 WPS / PSK / Open connection
A WPS connection enables the radio to be connected to your network in a simple yet protected man-
ner. There are two options available. Establishing the connection through
PBC = Push-Button-Configuration (configuration at the push of a button) or by the PIN proce-
dure, in which the web interface of your router prompts you to enter a randomly generated sequence
of numbers.
15.2.4 PBC setup
Select the desired network "[WPS ...]". Then select the "Push button" option in "WPS menu" and
confirm. Now press the WPS button on your router or access point (AP). Please refer to the operating
.
instructions of your router or AP for the exact procedure. Alternatively, the process can also be star-
ted in the "Network" menu under "PBC WLAN setup". Follow the instructions on the display.
15.2.5 Setup using PIN
Select the desired network "[WPS ...]". Then use the "WPS menu" to select and confirm the
"PIN"option. The radio now generates an 8-digit code, which you should confirm with the <OK>
button and then enter the number via the user interface of the router or AP. Please refer to the Rou-
ter or AP manual for more information.
22