Before Starting The Appliance; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - HERKULES LHS 210 Originalbetriebsanleitung

Anleitung_LHS_210_SPK7:_
GB
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.

5. Before starting the appliance

Before you connect the appliance to the mains supply
make sure that the data on the rating plate are
identical to the mains data.
Always pull the power plug before making
adjustments to the appliance.
5.1 Changing the abrasive paper (Fig. 2)
The sanding/grinding disk comes with a Velcro
fastening system for sanding/grinding paper. This
permits new sanding/grinding paper to be attached
without a clamping device.
Before you attach a new piece of sanding/grinding
paper, knock out any dirt from the Velcro fastener and
clean with a brush or, if necessary, with compressed
air.
Place the sanding/grinding paper on the
sanding/grinding disk. Fix the sanding/grinding paper
in place by pressing it firmly with your hand.
Caution:
Only grinding wheels with the specified diameter may
be used.
5.2 Fitting the dust extraction system (Fig 3/4)
The dust extraction system prevents the
accumulation of dirt and high dust loads in the air,
and it makes it easier to dispose of the dust.
Insert the dust extraction hose (6) into the mount
(5) Both interlocking lugs (a) should be snapped
into the notches (b) in the mount.
To dismantle the hose, carefully press into the
notches with the flat side of the enclosed
screwdriver. By doing this, the interlocking lugs
are released from the notches and the hose can
be taken back out of the mount.
Connect your appliance to an extraction unit or
vacuum cleaner. This will provide excellent
extraction of chips and dust from the workpiece.
Advantages: The advantages are that you will protect
both the appliance and your own health. Your work
area will also be clean and safe.
10
19.05.2009 8:25 Uhr Seite 10
6. Starting up
6.1 ON/OFF switch (Fig. 5)
To switch on the appliance set the On/Off switch (1)
to position 1.
Move the On/Off switch (1) to position 0 to switch off
the appliance.
6.2 Speed controller (Fig. 5)
To pre-select the speed turn the knurled screw (2) on
the switch.
Plus direction: Higher speed
Minus direction: Lower speed
6.3 Using the telescopic length extension (Fig.
6/7)
Unscrew the lock for the telescopic length extension
(3) approx. 2-3 turns (Fig. 6) Now the telescopic
length extension (4) can be pulled out (Fig. 7)
6.4 Swivelling grinding/sanding disk (Fig. 8)
The grinding/sanding disk swivels on 2 different axes
and therefore enables comfortable grinding/sanding
even for overhead work and for working in small
spaces.

7. Replacing the power cable

If the power cable for this appliance is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the appliance with a clean cloth or blast it
with compressed air at low pressure.
We recommend that you clean the appliance
immediately after you use it.
Clean the appliance regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the appliance. Ensure that no
water can get into the interior of the appliance.