Axis 216FD Installationsanleitung Seite 4

Page 4
Install the drop ceiling mount
1. If possible, remove the ceiling tile in which the drop ceiling mount is to
be fitted.
2. For greater security, the camera can be secured
using the supplied safety wire. Attach the end
with the lock to a suitable point in the ceiling
above the drop ceiling.
3. Use the supplied template to mark the position
for the 154 mm hole in the ceiling tile. Remove
the protective paper, fix to ceiling tile and cut
around the template.
Note:
The combined weight of the camera and ceiling mount is
0.82 kg (1.8 lb). Check that the ceiling material is strong
enough to support this weight. The thickness of the ceiling
should be 9-60mm (0.35"-2.4").
4. Tilt and insert the outer ceiling bracket through the hole, and then pull
it into place. The bracket should be positioned so that the 3 vertical tabs
point downwards in the hole.
Hole diameter 154-160mm
5. Pull all of the required cables (network, power, etc) and the safety wire
down through the hole, ready for connection.
Downloaded from www.Manualslib.com manuals search engine
AXIS 216FD Drop Ceiling Mount Installation
Attach to ceiling
Attach to camera
Ceiling tile
Outer ceiling bracket