Service And Maintenance - Protool PDC 12-4 TEC Li Originalbetriebsanleitung

8.4
Bits can be inserted directly into the hexa-
gon socket holder of the drill spindle.
8.5
The depth stop (partly as an accessory) al-
lows the user to insert screws to a pre-
defined depth. You can set the dimension
by which the screw head protrudes above
or is recessed below the surface of the
workpiece.
Depth setting
depth by 0.1 mm.
Sleeve A/B must be removed before a
screw can be unscrewed.
9
9.1
Press = ON, release = OFF
The speed of the machine depends on
how far the on/off switch is pressed in.
9.2
Magnetic, for storing bits and bit holders.
9.3
The user can attach the machine to work
clothing for short periods using the belt
clip (right/left).
9.4
Always use the additional handle.
Position the additional handle [5-2] on
the extension of the gearbox housing
and engage the recesses on the addi-
tional handle in the lugs on the housing.
Turn the handle until secured in posi-
tion.
Turn the handle to adjust the position in
30° increments.
The drilling depth can be adjusted using
the depth stop [5-1].
9.5
Acoustic warning signals sound and the
machine switches off in the following oper-
ating states:
Downloaded from www.Manualslib.com
Tool holder in the drill spindle
[9]
Depth stop [10]
Turn the housing [10-1] to
set the desired fastening
depth. Each detent position
changes the
Working with the machine
On/Off switch [1-4]
Bit depot [1-3]
Belt clip [1-10]
Attaching the additional han-
dle[5]
Acoustic warning signals
manuals search engine
– Preset torque reached.
– "Block protect" - starting torque too
peep
high.
– Machine overloaded
10

Service and maintenance

Risk of injury, electric shock
Always disconnect the battery pack from
the machine before any maintenance or
care work!
All maintenance and repair work which
requires the motor housing to be
opened, must only be carried out by an
fastening
authorised service workshop.
Note the following information:
– Keep the ventilation slits on the machine
free and clean to ensure adequate cool-
ing.
– Keep the contacts on the machine, char-
ger and battery pack clean.
Information on battery packs
– Store in a cool, dry place at a tempera-
ture between 5 °C and 25 °C.
– Protect battery packs from moisture,
water and heat.
– Do not leave flat battery packs in a char-
ger disconnected from the mains power
supply for longer than one month. Dan-
ger of deep discharge!
– If you intend to store li-ion battery packs
for longer periods without use, you
should charge them to 40 % capacity
(approx. 15 min charging time).
– To avoid short circuits the battery pack
should be stored in the packaging sup-
plied.
– Significantly shorter operating times af-
ter each charge indicate that the battery
pack is worn and should be replaced with
a new one.
10.1 After-sales service and repair
WARNING
Always contact the manufactur-
er or an authorised service
workshop. Find the address of
your nearest workshop at:
www.protool-online.com/ser-
vice
15