Maintenance And Cleaning - OP XPRO SAFETY XPROZO1.05 Betriebsanleitung

Air duct and climate control system disinfection
To disinfect the air ducts of the vehicle's climate control system, it is necessary to carry out the
disinfection treatment with the vehicle on, making sure that the driving position is in parking (P)
or in neutral for manual gearboxes and the parking brake activated (P). This operation must be
carried out with the climate control system and recirculation buttons active and in an airy
place so that the exhaust gases can be evacuated.
12

Maintenance and cleaning

Quartz technology guarantees a device life of 20,000 hours of work more than twice as long as
other versions on the market (e.g. ceramic plate).
The ozone generator requires no maintenance other than standard cleaning.
- Maintenance operations, especially those relating to internal components, must
be carried out only and exclusively by qualified personnel, such as a qualified
electrician.
- Unplug the power supply cord before cleaning the device.
- All operations must be carried out with cold equipment and with qualified
equipment/tooling
To access the internal components of the device, unscrew the screws on the sides of the chassis
(picture below):
- periodically remove any dust that may be deposited on the internal (D) and external (10) fan
grille using a vacuum cleaner or bristle brush;
- periodically clean the side air intakes by removing any dust deposits, using a vacuum cleaner or
bristle brush;
- in case of use in environments with air humidity >55%, some condensation could form inside
the ozone generator: it must be dried with a clean cloth or with the help of the hot air jet of a
hair-dryer.
26
Istruzioni Generatore Ozono.indd 26 Istruzioni Generatore Ozono.indd 26 03/05/2020 20:04:12 03/05/2020 20:04:12