Spektrum AR8010T Bedienungsanleitung Seite 5

Slide the feeder antennas through the holes until the 31mm tip, and about
2mm of coaxial, completely exit the fuselage. Use a drop of CA or tape to fix the
antenna to the fuselage.
IMPORTANT: Ensure that the 31mm active portion of each antenna tip is
fully exposed.
TIP: Use the optional (sold separately) Antenna Exit Guides (SPM6824) to safely
mount the antennas outside of the fuselage.
IMPORTANT: If the antenna is to be mounted internally (in the front of
a 2.4GHz friendly fuse), the coaxial can be taped into position. Ensure the
31mm tip is located at least 2 inches from any significant carbon structure.
Check that at least one antenna will always be in the RF visual line of sight of
the transmitter (e.g. not blocked by carbon fiber structures) in all attitudes. This
can easily be visualized by having a helper stand about 20 feet away and rotate
the airplane in all attitudes,
confirming that there is
a direct line between you
and at least one receiver
antenna that isn't blocked
by carbon fiber structure.
Binding
The AR8010T/AR9030T/AR9320T receivers must be bound to the transmitter
before they will operate. Binding is the process of teaching the receiver
the specific code of the transmitter so it will only connect to that specific
transmitter.
1. Connect the remote receiver and any telemetry sensors to the main receiver.
2. Push and hold the bind button on the receiver while powering up the
receiver. Release the Bind button once the orange LED starts to flash
continuously, indicating that the receiver is in bind mode.
Tip: It is still possible to use a bind blug in the BIND/BATT port if desired.
3. Put your transmitter in bind mode.
4. The bind process is complete when the orange LED on the receiver is solid.
NOTICE: If using a bind plug, remove after binding to prevent the system
from entering bind mode the next time the power is turned on.
5. After you set up your model, always rebind the transmitter and receiver to
set the desired failsafe positions. See FAILSAFE on the next page.
EN
5