Specifications - Maktec MT450T Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shoe
1-2. Shoe button
2-1. Shoe button
2-2. Shoe
3-1. Switch trigger
3-2. Lock button
4-1. Blade clamp sleeve
4-2. Fixed position

SPECIFICATIONS

Max. cutting capacities
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for sawing wood, plastic, metal and
building materials with a strong impact. It is suitable for
straight and curved cutting.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical
according to EN60745:
Model MT450T
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model MT450
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Downloaded from www.Manualslib.com
Explanation of general view
4-3. Released position
5-1. Blade
6-1. Blade clamp lever
7-1. Hex wrench
7-2. Screw
8-1. Screw
8-2. Pin
8-3. Blade clamp
Model
Length of stroke
Pipe
Wood
-1
Strokes per minute (min )
Overall length
Net weight
Safety class
A-weighted noise level
) : 87 dB (A)
pA
) : 98 dB (A)
WA
) : 88 dB (A)
pA
) : 99 dB (A)
WA
Wear ear protection
manuals search engine
MT450T
28 mm
130 mm
255 mm
0 - 2,800
457 mm
3.2 kg
ENE021-1
Vibration
The vibration
determined according to EN60745:
Work mode : cutting boards
ENF002-2
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : cutting wooden beams
Vibration emission (a
Uncertainty (K) : 2.0 m/s
ENG905-1
The declared vibration emission value has been
•
measured in accordance with the standard test
determined
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
8-4. Hole
8-5. Blade
9-1. Hex wrench
9-2. Insulation cover
11-1. Limit mark
12-1. Brush holder cap
12-2. Screwdriver
MT450
28 mm
130 mm
255 mm
0 - 2,800
457 mm
3.1 kg
/II
total value (tri-axial vector
2
) : 19.5 m/s
h,B
2
2
) : 22.0 m/s
h,WB
2
ENG900-1
sum)
ENG901-1