Commissioning; Before Using The Appliance For The First Time; Filling The Water Tank - SHE SHE20AC2001F Bedienungsanleitung

BEFORE USING THE APPLIANCE FOR THE FIRST TIME

Unpacking the Appliance
1. Open the carton and take out the appliance.
2. Remove all packaging from the appliance.
3. Unwind the mains cable completely and make sure not to damage it.
Transport wheels
For easier transport, the appliance is equipped with transport wheels.
In addition, two rollers are equipped with a locking brake to guarantee that they remain firmly
in position.
1. After the appliance has been carefully unpacked, insert the transport
rollers into the designated notches on the bottom of the appliance.
2. To adjust the locking brakes, press the levers as follows:
PRESS DOWNWARDS  to fix the brake
PUSH UPWARDS to release the brake
INSTALLATION
Please note the following points for installation.
1. Place the appliance on a level and solid surface and adjust the locking brakes so that
the appliance stands firmly in position.
2. There must be at least a 50 cm gap to walls or other objects.
3. Before using the appliance, make sure that both the air inlet and the air outlet are free
of obstacles and are not blocked.
4. Connect the appliance to an earthed outlet.

FILLING THE WATER TANK

Furthermore, please note the following:
1. Open the water refill flap on the side of the appliance.
2. Fill the air cooler with clean water, paying attention to the fill level on the front:
3. MIN mark  The water tank must be filled to above the MIN mark so that the pump
can function properly.
4. MAX mark  Avoid filling the water tank over the MAX mark, otherwise water could
enter the inside of the appliance and thus damage electronic parts.
5. Then close the flap again.
COOL PACKS
You will receive two cool packs that can be put into the water tank for a further cooling effect.
When using the cool packs, please note the following:

Before use, place the cool packs in a freezer for at least 3-4 hours.

When inserting the cool packs into the tank, make sure that the MAX mark is not
exceeded.

COMMISSIONING

Seite 19 von 134