Maintenance And Service; Disposal Information - WOLFF 010289 Originalbetriebsanleitung

5.0 Maintenance and Service

Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean.
After fi nishing work, dismount the clamping fi xtures and
clean all clamping parts as well as the protective cover.
When the carbon brushes are worn out, the machine
switches itself off .
The machine must then be sent to an after-sales ser-
vice agent. Addresses are listed in the Section "After-
sales service and customer assistance".
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
6.0 Troubleshooting
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the 10-digit article number specifi ed on
the type plate of the machine.
5.1 Spare parts
Spare parts are available on the Internet:
http://webcatalog.wolff -tools.com can be found.
Fault Possible cause
The machine
does not start Battery is empty
interrupted
Higher exer- Cutting blade
tion of force dull
required while
working
Machine auto- Overload protection
matically has been activa-
switches off ted
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff -tools.de

7.0 Disposal information

The machine, accessories and packaging should be sor-
ted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
disposed of in an environmentally correct manner.
Subject to change without notice.
Remedy
Charge battery on
station
Replace
cutting blade or
resharpen
Machine after
a cooling time
turn back on
According the European Guideline 2002/96/
EC for Waste Electrical and Electronic
Equipment and its implementation into na-
tional right, power tools that are no longer
usable must be collected separately and
EN
22