WOLFF 010289 Originalbetriebsanleitung Seite 21

EN
► Check the cutting blades before use. The
cutting blade(s) must be mounted properly
and must be able to rotate freely. Carry out a test run
for at least 60 seconds without any load. Do not use
cutting blades that are damaged, out-of-balance, or
vibrate. Damaged diamond cutting blades can
rupture and lead to injuries.
4.4 Working Advice
► Do not strain the machine so heavily that it comes
to a standstill.
► The machine may only be used for dry cutting.
– Adjust the cutting depth, see section "Pre-selectingthe
Cutting Depth".
– Guide the machine with both handles, applyingmodera-
te feed, suited to the material being worked.
– The machine must always work in an upward grinding
motion. Otherwise, the danger exists of it being pushed
uncontrolled out of the cut.
– After fi nishing the working procedure, swivel the cutting
unit out of the slot with the machine still running, until
Warning
the cutting unit engages in the uppermost position.
– Switch the power tool off .
► Cutting blades become very hot during
operation; do not touch them until they have co-
oled down.
WARNING!
Before carrying out any work on the power tool, remove
the battery from the device. Unpack the Doortrimmer be-
fore putting it into operation and check that the delivery is
complete and Check for transport damage.
NOTE
The batteries are not fully charged on delivery.
Fully charge the batteries before using them for the fi rst
time. Refer to the operating instructions of the charger.
4.5 Inserting/changing the battery Figure F+G
► Charged battery until fully charged
Push the catch into the power tool
► To remove the unlocking buttons
Press (1.) and pull out the battery (2.).
21
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff -tools.de
Do not brake coasting cutting blades by
applying pressure to the side.
CAUTION!
When not in use, disconnect the contacts of the battery
protect. Loose metal parts can short-circuit the contacts,
4.6 Battery charge status Figure H
there is a risk of explosion and fi re!
► By pressing the button, the battery status LED can be
used to check the battery charge status.
► The display goes out after 5 seconds.
If one of the LEDs fl ashes, the battery must be char-
ged. If no LED lights up after pressing the
4.7 Using rechargeable batteries
button, the battery is defective and must be replaced.
► Only use original batteries with the capacity indicated on
the type plate of your power tool.
Voltage. If other batteries are used, e.g. imitations, re
conditioned batteries or batteries from other manufactu
rers, there is a risk of injury and damage to property.
damage caused by exploding batteries.
► Only charge the batteries with chargers recommended
by the manufacturer. Using a charger suitable for a
specifi c type of battery, there is a risk of fi re if it is used
with other batteries is used.
► The battery can be damaged by pointed objects such
as nails or screwdrivers or by external force. This can
lead to an internal Short circuit and the battery may burn,
smoke, exploden or overheat.
► For marking the power tool only use adhesive labels. No
holes into the housing.
► Spindle lock only when stationary
4.8 Clean the dust fi lter regularly Figure I
Press grinding tool.
► Remove the dust fi lter and clean it with dry
4.9 Unlocking Figure J
Blow out compressed air.
► By pressing the bolt (17) the machine is
unlocked and can still be pushed forward.
When springing back, the latch snaps automatically
back to his starting position.