Blaupunkt ADH701 Bedienungsanleitung Seite 9

ADH701
Your products is designed a manufactured with high quality materials and components,
which can be recycled and reused.
TECHNICAL SPECIFICATIONS
Rated power: 390W(27°C, 60%)
Maximum power consumption: 510W (32°C, 90%)
Maximum current: 2,4A (32°C, 90%)
Voltage: 220-240V ~50Hz
Tank volume: 5,5l
Air-flow rate: 195m³/h
Refrigerant: R290/75g
Maximum noise level: ≤47dB(A)
Maximum condensation pressure: 3,3,3,2MPa
Maximum evaporation pressure: 1,5 Mpa
Recommended air filter: Blaupunkt ACC032
1. Control panel
1a. Display
1b. Power on/off button
1c. MODE button
1d. TIMER button
1e. + and – buttons
1f. Oscillation button
1h. Full-water-tank indicator
1i. Operating-mode indicators
(Silent/Strong/Continuous/Auto)
1j. Defrosting-mode indicator
INSTRUCTIONS FOR USE
1. Start-up procedure
Press the power on/off button (1b). The unit will switch on in the last selected mode.
2. Shutdown procedure
Press the power on/off button (1b). The unit will switch off after a while. Do not interrupt the shutdown
procedure by removing the plug from the electrical outlet.
3. To change the operating mode: press the MODE button (1c). Each time you press the button, the
mode will change in the following sequence: Auto (automatic mode), Silent (silent mode), Strong (fast-
drying mode), Continuous (continuous-drying mode). Press again to return to the Auto mode. The
operating mode indicators (1i) show the current operating mode.
Automatic mode: the target humidity level is set at 55%; the fan speed depends on the ambient
humidity level.
Silent mode: the fan speed is at its lowest - you can set the target humidity level.
Fast-drying mode: the fan speed is at its highest, and the drying process goes on in continuous mode.
Continuous-drying mode: the fan speed is at its lowest, and the drying process goes on in continuous
mode.
4. Adjustment of the target humidity level: set the target air-humidity level using the + and –
(1e) buttons: 35%-80% (at 5% increments). The target humidity level can only be set in the silent mode.
5. Oscillation of the air-outlet fins: the oscillation mode can be activated or deactivated using the
oscillation button (1f ).
6. Full-tank indicator: if the tank is full of water, the dehumidifier will terminate the drying process and
1k. Timer and oscillation indicators
2. Air outlet
3. Air inlet grille
4. Water tank
4a. Water-tank handle
5. Handle
6. Water outlet
7. Tube for continuous water drainage (12 mm)
8. Lateral display with LED indicator
7