Grundig Heinzelmann Bedienungsanleitung Seite 26

SYSTEM SETTINGS ___________________________
SLEEP
To set the sleep timer, select Sleep under Main
menu. Choose from Sleep OFF, 15, 30, 45 or 60
minutes and confirm. Once you select a sleep
period, the system returns to the now playing
screen.
ALARM
There are two versatile wake-up alarms with
snooze facility. Each alarm can be set to start in a
particular mode.
Select Alarms under Main menu, or press the
Alarm button on the radio to enter alarm setup
menu.
After setup all the alarm parameters, select Save
to activate. The screen shows active alarms with
an icon at the top.
At the set time, the alarm will sound. To temporarily
silence, press any buttons or knobs, except
Standby/Mode knob, into the snooze period. The
radio returns to standby for the set period, with the
silenced alarm icon flashing.
Press the Standby/Mode knob on the device or
Standby button on the remote turn the current
alarm off.
EQUALISER
Several preset EQ modes are available: Normal,
Flat, Jazz, Rock, Movie, Classic, Pop, News and
My EQ.
Press the Menu/Return button on the device or the
remote control to display menu. Press the OK/Scan
knob or press OK button on the remote control
while displaying "System settings" to enter. Then
rotate the OK/Scan knob or press UP/DN button to
choose "Equaliser", press the knob to enter EQ list.
26 ENGLISH
A user-defined setting is available; create your
own EQ with custom bass and treble settings.
Rotate the OK/Scan knob or press UP/DN button
on the remote control to choose My EQ to activate
the customized EQ settings, select My EQ profile
setup to enter My EQ setup.
You can rotate the OK/Scan knob or press UP/
DN button on the remote control to adjust bass or
treble, then press the knob or OK button on the
remote control to confirm.
NETWORK
Network wizard:
Enter to search AP SSID, then input the WEP /
WPA key or choose Push Button/Pin/Skip WPS to
connect to the wireless network.
PBC Wlan setup:
Push Button Configuration, it is to connect the AP
that supports WPS (Wi-Fi Protected Setup).
View settings:
View the information of current connected network:
Active connection, MAC address, Wlan region,
DHCP, SSID, IP address, Subnet mask, Gateway
address, Primary DNS and Secondary DNS.
Manual settings:
Enable or disable DHCP (Dynamic Host
Configuration Protocol). Input the SSID, WEP / WPA
key and/or other configuration.